. Given the diagram below and OSPF properly configured on routers 1 and 2.

The network engineer typed two Cisco IOS commands in the Command Line Interface (CLI) back to back and observed the output below.

Explain how the cost to the 192.168.1.0/24 route was calculated in OSPF. (15 points)

R2#show ip route

Codes: L – local, C – connected, S – static, R – RIP, M – mobile, B – BGP

D – EIGRP, EX – EIGRP external, O – OSPF, IA – OSPF inter area

i – IS-IS, L1 – IS-IS level-1, L2 – IS-IS level-2, ia – IS-IS inter area

* – candidate default,

O 192.168.1.0/24 [110/65] via 192.168.23.1, 00:03:44, Serial0/3/0

O 192.168.2.0/24 [110/65] via 192.168.23.1, 00:03:44, Serial0/3/0

192.168.3.0/24 is variably subnetted, 2 subnets, 2 masks

C 192.168.3.0/24 is directly connected, GigabitEthernet0/0

192.168.23.0/24 is variably subnetted, 2 subnets, 2 masks

C 192.168.23.0/24 is directly connected, Serial0/3/0

! Removal of unnecessary lines.

R2#show interface s0/3/0

Serial0/3/0 is up, line protocol is up (connected)

Hardware is HD64570

Internet address is 192.168.23.2/24

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, loopback not set, keepalive set (10 sec)

! Removal of unnecessary lines.

R2# ATTACHMENT PREVIEW Download attachment

screenshot_22.png

Given the diagram below and OSPF properly configured on routers